EcoTech Marine is pleased to present its newest offering to the hobbyist and retailer community - a coral glue that actually works!

Gluing coral and live rock is frequently a difficult, messy and time-consuming task. Small bottles make it hard to squeeze out the glue and then it hardens between uses. Runny cyanoacrylates and stiff epoxies further compound the unpleasantness of this experience.

With a larger size, an optimal consistency and an optimal set time, EcoTech's coral glue is an adhesive that really improves the ability to properly glue frags.

A replaceable pin cap and a shelf life of up to two years (especially if refrigerated) ensure that you will actually get to use it more than once.

Directions:

1. Ensure in-tank flow is off
2. Apply glue to coral or rock above or under water
3. Hold item in desired location until stable
4. Allow glue to set and cure before turning flow back on

Note: The glue creates a support structure, don’t be shy with the volume

  “I’ve used lots of other glue and epoxy products in my saltwater tank, and none of them worked as well as EcoTech’s Coral Glue. EcoTech’s glue held frags in place and kept them in place as well as secured my rock work for me after the epoxy holding it together failed. Now I’ve thrown away all my other epoxy and superglue and replaced it with EcoTech’s Coral Glue.”
 -Mark,  Austin, TX

“I was very pleased trying out this new glue and would recommend it to friends and hobbyist.”
 -Eric,  Allentown, PA

“I thought all glues were the same until I tried the EcoTech Elements glue.  Frags instantly stick to the plug and best of all stay there!”
 -Derrick,  Arvada, CO